PlayStation®2 30000 - 50000 Series / Installation

Installing Using an RFU Adaptor

To install your PlayStation®2 computer entertainment system using an RFU adaptor:

  1. Connect the cables

    Connect the flat end of the RFU adaptor to the AV MULTI OUT connector on the back of the PlayStation®2.


  • Connect the other end of the RFU connector, labeled RFU OUT, to the cable connector on the back of your TV. The cable connector is where you ordinarily connect your coaxial cable for an antenna, cable TV, or VCR.

    Then plug the coaxial cable that usually connects to the back of the TV into the ANT input on the RFU adaptor.


  • Set the RFU adaptor switch to either channel 3 or 4, whichever channel is not used for TV in your area.


  • Connect the AC power cord into the PlayStation®2 system and plug it into a working electrical outlet.


  1. Start the system

    Turn on your PlayStation®2 by pressing the MAIN POWER switch on the back of the system.


  • Press the standby/RESET button on the front of the system. Make sure the indicator light turns green.


  • Press the open button, place a PlayStation®2 disc in the tray, and press the open button again to close the tray.


  1. Set up the TV

    Turn on your TV.


  • Set your TV to the same channel as the RFU adaptor switch setting, either channel 3 or 4.


  • Press the TV/Video button on your TV�s remote control. The TV/Video button might also be called the Input, AUX, or Line button on your remote. Use the setting you would if you were going to watch a movie.