PlayStation®2 70000 Series / Installation

Installing Using an RFU Adaptor

To install your PlayStation®2 computer entertainment system using an RFU adaptor:

  1. Connect the cables

    Connect the flat end of the RFU adaptor to the AV MULTI OUT connector on the back of the PlayStation®2.


  • Connect the RFU OUT connector to the cable connector on the back of your TV. The cable connector is where you ordinarily connect your coaxial cable for an antenna, cable TV, or VCR.

    Then plug the coaxial cable that usually connects to the back of the TV into the ANT input on the RFU adaptor.


  • Set the RFU adaptor switch to either channel 3 or 4, whichever channel is not used for TV in your area.


  • Connect the AC adaptor to the AC power cord. Then connect the other end of the AC adaptor to the back of the PlayStation®2 system.


  • Plug the AC power cord into a working electrical outlet.


  1. Start the system

    Press the on/standby/RESET button on the front of the PlayStation® 2 system. Make sure the indicator light turns green.


  • Press the open button on the front of the system and place a disc in the disc tray. Press down gently on the disc until all three tabs on the disc holder are above the surface of the disc. Then press the "PUSH" label on the disc cover to close it.


  1. Set up the TV

    Turn on your TV.


  • Set your TV to the same channel as the RFU adaptor switch setting, either channel 3 or 4.