PlayStation®2 30000 - 50000 Series / Network Adaptor

Setup Troubleshooting

If the Network Adaptor Start-up Disc cannot find the network adaptor: Back to top


  • Turn off and unplug the PlayStation®2 computer entertainment system.
  • Make sure the network adaptor is installed correctly. Please see the network adaptor installation instructions.
  • Make sure you are not over-tightening the mounting screws, because this may cause a connection error.
  • Plug in the PlayStation®2 system and run the Start-up Disc again.

If a blank screen replaces the Browser screen shortly after the system is turned on: Back to top


  • Turn off and unplug your PlayStation®2.
  • Using a coin, slightly loosen the network adaptor.
  • Plug the power cord into the outlet, turn on your PlayStation®2 system and run through the network configuration process. Please see Create a network configuration.

If the Browser screen remains frozen on the screen after the system is turned on: Back to top


  • Turn off and unplug your PlayStation®2.
  • Turn on your PlayStation®2 system and run through the network configuration process. Please see Create a network configuration.

If the Reset button on the front of the system is not working: Back to top


  • Double-tap the RESET button. This will reset the system.

If the system freezes while transferring information from the network adaptor: Back to top


  • Reset your PlayStation®2 system by turning off the main power switch on the rear of the system and starting it again.

    NOTE: You may lose any data you were transferring at the time of lock-up (freeze).

- or -
  • Hold down the Reset button on the front of the PlayStation®2 system for approximately 5 or more seconds.

    NOTE: You may lose any data you were transferring at the time of lock-up (freeze).

Additional Support Back to top